【New】13-step lighting truss construction steps

1. Set the four bases in the approximate position on the ground and adjust the lower legs to make them in a horizontal plane.

2. Insert the bottom part of the diagonal support on the outside of the base on the four corners, and insert 2 pieces into each corner for a total of 8.

3. Fix the counter head with the screw on the base. Note that the direction of rotation of the counter head is the same as that marked in the figure.

4. set the square on the counter.

5. Connect the beams on the ground.

6. Connect the two ends of the beam to the two square sleeves on both sides, and the beam parts are assembled on the ground.

7. Connect the column truss flat and lay it, then screw one end to the opposite head and the other end to the cross arm. At the same time, link the hanging hoist and cross arm. The function of the hoist is to raise the lower beam truss. .

8. A number of people will slowly erect the column truss together, taking care not to push the column too hard, and then fix the screw on the counter head.

9. After the column is erected, hook the hook below the hanging hoist through the sling to the lower beam.

10, 4 people slowly swayed the hoist to pull the beam to the left and right position of the person's head.

11. Install the lighting equipment that you need to install on the beam.

12, 4 people swayed the hoist together to stop at the predetermined height.

13. Tighten one end of the diagonal support and stand tightly, and tighten the other end to the horizontal support of the base, so that the aluminum frame is completed.